So I decided today that I really needed to close the book on the color preamp. This means that I couldn’t just prototype a new buffer and leave it at that. The preamp needed an end-to-end test in it’s final design configuration. So that’s what I did. The results were even better than before.
Continue readingLots of work has been going on the last couple of days working on an alternate buffer design for the 12AU7 “Color” preamp. As readers should know, I was not particularly pleased with the performance of the previous buffer circuit. It was bottoming out at too low a voltage. Now however, I have a simple change which yields much better results.
Continue readingThis afternoon I completed the “color” preamp and tried it out. I am very happy with the results.
Continue readingI had thought that the coupling capacitors I ordered on Tuesday would not arrive until this Saturday. However, the gods of DIY decided to smile down upon me and the capacitors showed up in today’s mail delivery. In my opinion, two days from order to delivery is exceptional. I spent some time this afternoon with a soldering iron in hand and the Color Preamp is now fully assembled.
Continue readingI made significant progress today. Most of the signal stage wiring is done. I could finish it up in about half an hour, but there are two little blockages in my path; one due to a supplier problem, one due to me.
Continue readingI’ve been working on the color preamp over the last few days as I’ve had time. My volume control and output capacitors are supposed to arrive today so it shouldn’t take too much longer to finish it up. However working inside the small chassis is a challenge.
Continue readingFor a while now, ever since the “Universal Preamp” was posted on the site, I’ve been getting steady requests for a good tube preamp to provide some color to solid state amplifiers. My initial answer to this problem was to design a good quality cathode follower for the Universal Preamp. There was one problem, the volume control.
Continue reading